Table of Contents
Advertisement
GETTING STARTED
Hook on.
BATTERY RELEASE Switch
Battery pack
To AC outlet
CHARGING THE BATTERY PACK
1) Hook the end of the battery pack to the
camcorder and push the battery in until it locks
in place.
• If the battery pack is attached in the wrong
position, a malfunction may occur.
2) Set the Power Switch
down the Lock Button
Connect the AC Adapter to the DC IN connector
9
, then connect the Power Cord to the AC
Adapter.
3) Plug the Power Cord into an AC outlet. The
)
CHARGE lamp
has started.
4) When the CHARGE lamp
stays lit, charging is finished. Unplug the AC
Adapter from the AC outlet. Disconnect the AC
Adapter from the camcorder.
To Detach The Battery Pack . . .
... slide BATTERY RELEASE
battery pack.
Battery pack
BN-V11U
BN-V12U (optional)
BN-V20U (optional)
BN-V400U (optional)
Charging times are for a fully discharged battery pack.
Push in.
Power Switch
To DC IN
connector
AC Adapter
@
to "OFF" while pressing
!
located on the switch.
blinks to indicate charging
)
stops blinking but
8
and pull out the
Charging time
approx. 1 hr. 40 min.
approx. 1 hr. 40 min.
approx. 2 hrs. 40 min.
approx. 5 hrs. 10 min.
USING THE BATTERY PACK
Perform step 1) of "CHARGING THE BATTERY
PACK".
Approximate recording time (unit: min.)
Battery pack
Viewfinder on
1
BN-V11U
90
(45)
BN-V12U
90
(optional)
(45)
BN-V20U
140
(80)
(optional)
BN-V400U
340
(optional)
(195)
1
When using models equipped with LCD monitor
2
When using GR-SX25/FX15
( ): when the video light is on
(GR-SXM49/FXM393/SX25 only)
USING AC POWER
Connect the AC Adapter to the camcorder (
2) and 3) of "CHARGING THE BATTERY PACK").
• The provided AC Adapter features automatic
voltage selection in the AC range from 110 V to
240 V.
Before detaching the power source, make sure that
the camcorder's power is turned off. Failure to do
so can result in a camcorder malfunction.
REFRESH:
Be sure to fully discharge a battery pack before
recharging or storing it for a long period of time,
otherwise the battery performance will be reduced.
1) Perform steps 1) through 3) of "CHARGING
THE BATTERY PACK".
2) Press REFRESH
$
POWER lamp
has started.
3) When discharging is finished, charging
automatically starts and the CHARGE lamp
blinks.
Charge marker helps you remember
whether the battery pack has been
charged or not. Two colours are provided
(red and black)—you choose which one
means charged and which means
discharged.
6
LCD monitor on
2
95
(50)
95
(50)
150
(85)
360
(205)
ATTENTION
q
for over 2 seconds. The
blinks to indicate discharging
1
80
(45)
80
(45)
130
(75)
305
(185)
step
)
Hide quick links:
Advertisement
Table of Contents
