DeWalt D28410 User Manual page 10

E N G L I S H
• Fit the inner fl ange (10) correctly onto the spindle
(11) (fi g. C1).
• Place the disc (12) on the fl ange (10) (fi g. C2).
When fi tting a disc with a raised center, make
sure that the raised centre (13) is facing the
fl ange (10).
• Screw the outer fl ange (14) onto the spindle (11)
(fi g. C3):
- the ring on the fl ange (14) must face towards
the disc when fi tting a grinding disc (A);
- the ring on the fl ange (14) must face away from
the disc when fi tting a cutting disc (B).
• Press the spindle lock (3) and rotate the spindle
(11) until it locks in position (fi g. C2)
• Tighten the fl ange (14) with the two-pin spanner
supplied.
• Release the spindle lock.
• To remove the disc, loosen the fl ange (14) with
the two-pin spanner.
Do not use a damaged disc.
Mounting the side handle (fi g. D1 & D2)
• For grinding, screw the side handle (5) tightly into
one of the holes (15) on either side of the gear
case (fi g. D1).
• For cutting, screw the side handle (5) tightly into
the top hole (16) or into one of the holes (17) on
either side of the gear case (fi g. D2).
D28423/D28432C - Rotating the main handle
(fi g. E1 & E2)
The rotary handle facilitates a more comfortable
handling in cutting applications with the side handle
mounted in the top hole.
The rotary handle has locations at 30°, 60° and 90°
both left and right.
• Pull the spring-loaded tab (18) to unlock the
rotary mechanism (fi g. E1). Hold the tab in the
pulled-out position.
• Rotate the handle (19) into the desired position
(fi g. E2).
• Release the tab and lock it in position.
• Check that the rotary mechanism is locked.
10
Do not use the tool unless the rotary
handle is in the locked postion.
Instructions for use
• Always observe the safety instructions
and applicable regulations.
• Ensure all materials to be ground or cut
are secured in place.
• Apply only a gentle pressure to the tool.
Do not exert side pressure on the disc.
• Avoid overloading. Should the tool
become hot, let it run a few minutes
under no load condition.
Prior to operation:
• Install the guard and appropriate disc or wheel.
Do not use excessively worn discs or wheels.
• Be sure the inner and outer fl ange are mounted
correctly.
• Make sure the disc or wheel rotates in the direction
of the arrows on the accessory and the tool.
Switching on and off (fi g. A)
The on/off switch is equipped with an unlocking
switch or a locking switch for continuous operation.
On/off switch (1) with locking switch (2)
• To run the tool, depress the locking switch (2)
and subsequently operate the on/off switch (1).
• Release the locking switch (2).
• To stop the tool, press the on/off switch again.
On/off switch (1) with unlocking switch (2)
(France only)
• To run the tool, depress the unlocking switch (2)
and subsequently operate the on/off switch (1).
• Release the unlocking switch (2).
• To stop the tool, release the switch.
Do not switch the tool on or off when
under load.
Consult your dealer for further information on the
appropriate accessories.