Chevrolet 2013 VOLT Owner's Manual page 87

Turning Bluetooth On or Off
1. Press the CONFIG button.
0
2. Press / on a navigation
radio.
3. Select Bluetooth.
4. Select Activation.
Changing Bluetooth Code
The default Bluetooth code should
work with most mobile phones.
If you are having difficulty pairing
your mobile phone, you can change
the code at any time.
1. Press the CONFIG button.
0
2. Press / on a navigation
radio.
3. Select Bluetooth.
4. Select Change Bluetooth Code.
5. Enter a new four-digit code, then
select OK.
Ring Tone
There are three different ring tones
available for the UHP system.
To change the ring tone:
1. Press the CONFIG button.
0
2. Press / on a navigation
radio.
3. Select Ring Tones.
4. Select Ring Tone 1, 2, or 3.
Default Settings
Selecting this option will reset the
ring tones and the Bluetooth code.
Pairing
A Bluetooth-enabled mobile phone
must be paired to the UHP system
first and then connected to the
vehicle before it can be used. See
the mobile phone manufacturer's
user guide for Bluetooth functions
before pairing the mobile phone.
Pairing information:
Up to five mobile phones can be
paired to the UHP system.
The pairing process is disabled
when the vehicle is moving.
Infotainment System
The UHP system connects with
the first available paired mobile
phone in the order the phone
was paired.
Only one paired mobile phone
can be connected to the UHP
system at a time.
Pairing should only need to be
completed once, unless changes
have been made to the pairing
information or the mobile phone
is deleted.
SIM Access Profile
(SAP) Mode
If equipped, this feature allows a
wider range of functions via the
phone portal including security and
messaging functions. The functions
depend on the network provider. In
SAP mode, the phone is in standby
mode and only the Bluetooth
connection and SIM card are active,
which leads to lower energy usage.
87