Datamax I-Class Mark II Installation And Use Manual page 5
General purpose input output (gpio) option
Hide thumbs
Also See for I-Class Mark II:
- Operator's manual (96 pages) ,
- Maintenance manual (74 pages) ,
- Quick start manual (4 pages)
Table of Contents
Advertisement
C) Remove the 5mm Screw and Cover
Plate from the rear of the printer.
D) Remove the two Jack Screws from
the GPIO Card, (these will be re-
installed later in the procedure).
E) Install the two 6mm Standoffs into the main board in the locations shown.
Cover Plate
5mm Screw
Jack
Screws
6mm
Standoffs
3
- Quick Links:
- Installing the Option
- Setup and Operation
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the I-Class Mark II and is the answer not in the manual?
Questions and answers