Datamax I-Class Mark II Installation And Use Manual page 11

Test an Diagnostics
Input Monitor – Display incoming GPIO binary signal states using the

DIAGNOSTICS  OPTIONS TESTING  TEST GPIO  MONITOR GPIO INPUT
selection.
Note: Unused, non-connected inputs will have an indeterminate state, and may

assume a value of 1 or 0.
Output Monitor – Display outgoing GPIO binary signal states using the

DIAGNOSTICS  OPTIONS TESTING  TEST GPIO  TEST GPIO OUTPUT
selection.
Note: Unused, non-connected outputs will have an indeterminate state, and may

assume a value of 1 or 0.
 GPIO Report – Print the configuration and current signal state information using the
DIAGNOSTICS  OPTIONS TESTING  TEST GPIO  PRINT SIGNAL INFO
selection:
SOP FEED
1 1
EP RL SR MO
1 1 1
GPIO SIGNAL INFO
WED 11:04AM 4JUL2011
CARD ID#3
OUTPUT SIGNALS
END OF PRI NT
PIN# 11 GPIO A
LOW PULSE
CURRENT LEVEL 1
RIBBO N LOW
PIN# 9 G PIO A
ACTIVE LOW
CURRENT LEVEL 0
SERVI CE REQUIRED
PIN# 10 GPI O A
ACTIVE LOW
CURRENT LEVEL 1
MEDIA OUT
PIN# 12 GPI O A
ACTIVE LOW
CURRENT LEVEL 1
RIBBO N OUT
PIN# 13 GPI O A
ACTIVE LOW
CURRENT LEVEL 1
DATA READY
PIN# 14 GPI O A
ACTIVE LOW
CURRENT LEVEL 1
OPTIO N FAULT
PIN# 15 GPI O A
ACTIVE LOW
CURRENT LEVEL 1
PAUSE REPRT
1 1
RO DR OF
1 0 1 0
INPUT SIGNALS
START OF PRINT
PIN# 3 GPIO A
ACTIVE HIG H
CURRENT LEVEL 1
FEED
PIN# 4 GPIO A
ACTIVE LOW
CURRENT LEVEL 1
TOGGLE PAUSE
PIN# 5 GPIO A
ACTIVE LOW
CURRENT LEVEL 1
REPRINT
PIN# 6 GPIO A
ACTIVE LOW
CURRENT LEVEL 1
9