Symbol Series 3800 Reference Manual page 117

4. Select Default Router from the main configuration menu. The Default Router screen
(Figure E-5) is displayed.
The default router address is the address of the node where all packets going to
remote networks are sent.
To change the current Default Router setting, backspace over the current value and
type a new value, in decimal form. Each part of the four-part address must be in the
range 0 to 255.
Press <ENTER> to effect the change. Press <CLEAR> to exit without changes.
5. Select Terminal IP Address from the main configuration menu. The Terminal IP
Address screen (Figure E-6) is displayed.
Note: Entering a Terminal IP Address is necessary only if IP addresses are
not being allocated by a boot server. IP address allocation is part of
the BOOTP and DHCP process.
DEFAULT ROUTER
Enter Default Router
157.235.93.178
BkSp, Clear, Enter
Figure E-5. Default Router Screen
TERMINAL IP ADDRESS
Enter IP address:
157.235.93.186
BkSp, Clear, Enter
Figure E-6. Terminal IP Address Screen
Spectrum24 Network and Flash Disk Utilities
E-5