Bel Canto e.One series User Manual page 8

The DAC1.5 Remote Control has a comprehensive
set of control features that are not available on the
front panel.
To access all DAC1.5 control features press the
button marked DAC on the remote control. The
Main CD controls will still operate in the DAC,
PRE and Tuner modes.
Display: Toggles through several display options:
1. Normal mode with Level Displayed
2. Input Sample Rate Displayed for several
seconds, example 44.1 or 96 or LOS
indicating Loss of Signal or no digital input
detected.
3. Display Off: Display comes on for several
seconds whenever a status change is
detected
Mute: When in variable output mode this will switch
the analog outputs from Soft to Hard Mute and Un-
muted modes. Soft mute is indicated by two decimal
points in the far right of the display. Hard mute is
indicated by 3 decimals on the display. The Mute
function will Punch Through to any Bel Canto unit
set in Variable Output mode.
VOL+: Increases the volume setting in Variable
Output mode. This will Punch Through to any Bel
Canto unit in Variable Output mode. The display will
show the volume level while changing.
VOL-: Decreases the volume setting in Variable
Output mode. This will Punch Through to any Bel
Canto unit in Variable Output mode. The display will
show the volume level while changing.
CH/SCAN+: This will toggle the input selection up in
number and wrap around. Note that the first press of
this control will show the active input selection.
CH/SCAN-: This will toggle the input selection down
in number and wrap around. Note that the first press
of this control will show the active input selection.
Number Buttons: Use for direct input selection.
1: AES 2: SPDIF1 3: SPDIF2 4: TOSLINK 5: USB