Bel Canto e.One series User Manual
Upsampling audio dac with master reference ultra-clock
Hide thumbs
Also See for e.One series:
- User manual (12 pages) ,
- User manual (14 pages) ,
- User manual (10 pages)
Related Manuals for Bel Canto e.One series
Summary of Contents for Bel Canto e.One series
- Page 2 Design. The content of this manual is provided for information use only, is subject to change without notice, and should not be construed as a commitment by Bel Canto Design Limited. Bel Canto Design Limited assumes no responsibility or liability for any errors or inaccuracies that may appear in this manual.
- Page 3 Explanation of symbols used in this manual or on the CAUTION rear/underside of the apparatus: • To reduce the risks of electric shock, do not remove the cover. • No user serviceable parts inside. This symbol is intended to alert the user to •...
- Page 4 Fit a new 10 amp BS1362 approved fuse into the carrier GROUNDED. and push the carrier back into the plug. Bel Canto Design Ltd. declare that this product is in conformance The conformity of the designated product with the provisions of with the Low Voltage Directive 73/23/EEC and Electromagnetic...
- Page 5 If the packing becomes Bel Canto Design. lost or damaged, please contact your dealer, distributor or Bel Canto before attempting to transport your unit This product, like any electrical component, can be The power supply on the DAC1.5 is preset for the...
- Page 6 Because the DAC1.5 runs cool, it can be placed in Single Ended RCA and Balanced XLR connectors many system locations without compromise. We do are available. XLR jacks allow balanced hookup not recommend placing weights or other objects using the standard North American pin configuration: directly on the DAC1.5.
- Page 7 Upon Power Up: Fixed Output Operating Mode: When switched on, the DAC1.5 will display its Pressing the rear panel Fixed/Variable Output switch software revision. The AES input will be selected to the in position will set the DAC1.5 in a fixed output and Soft Mute will be active.
- Page 8 The DAC1.5 Remote Control has a comprehensive set of control features that are not available on the front panel. To access all DAC1.5 control features press the button marked DAC on the remote control. The Main CD controls will still operate in the DAC, PRE and Tuner modes.
- Page 9 IMPORTANT: If using the DAC1.5 directly into a power amplifier, ensure that the Fixed/Variable Output button is in the OUT (variable) position. Operation in Fixed Mode directly into the amplifier could cause extreme output levels, clipping and damage to the loudspeakers, amplifiers or your ears! Beginning in the upper right: 2.1mm power input jack for the supplied TOSLINK Input accepts any standard plastic...
- Page 10 Using Headphones When headphones are inserted into the headphone jack, the volume can be adjusted via the control knob or remote regardless of whether the DAC1.5 is in Fixed or Variable mode. The input can be selected as normal from the front panel or remote.
- Page 11 Digital Section: Maximum Input Data Rate: 24bit Data at 192Ks/s: TOSLINK, AES 110ohm XLR, SPDIF 75ohm 24bit Data at 96Ks/s: Master Clock jitter: 2picosecond RMS Analog 24/192 DAC Section: Maximum Output: 4Vrms balanced XLR, 2Vrms RCA Output Impedance: 200 ohms balanced XLR, 100 ohms RCA Frequency Response: 20 Hz-20KHz, +/- 0.5dB THD+N:...