Quick Operating Guide; Installing Batteries In The Scorpion; Installing The Battery In The Tx9 Remote Control; Turning On The Scorpion X1B - Foxpro Scorpion X1-B Instruction Manual

1.0 QUICK OPERATING GUIDE

Since the Scorpion is shipped from the factory without batteries installed, the
first step is to install 8 "AA" batteries. These may be alkaline or rechargeable
types.
NOTE: We strongly recommend high capacity NiMH rechargeable batteries
over alkaline types for maximum performance, particularly when using loud
volume levels. Never attempt to recharge alkaline batteries! Doing so either
accidently or purposefully will void the warranty.
1.1 Installing Batteries:
Unlatch the door (latches are found on the side of the unit.) Orient the batteries
as per the directions shown in each cavity within the holder.
NOTE: The battery polarity alternates.
1. Close the top of the unit and press the latches until they "click," which
will keep the unit closed securely after the batteries are installed.
1.2 Installing the TX9 Battery
The TX9 transmitter operates from a 9V battery. Please use a high quality
alkaline battery.
1. Remove the battery compartment cover located on the rear of the
transmitter.
2. Connect the 9V battery to the connector plug, and orient the battery in
the transmitter.
3. Replace the battery compartment cover.

1.3 Turning on the SCORPION X1B

The SCORPION X1B is equipped with a power toggle switch on the front of the
Page | 5