Volume Control; Timer; Setting Presets P1 And P2 - Foxpro Scorpion X1-B Instruction Manual

The recall button remembers the last sound and volume level that you were
operating with. For example, if you are playing sound 001 at volume 9, and
then switch to sound 002 at volume 5, by pressing the recall button you will
jump back to sound 001 and volume 9.

5.6 Volume Control

The TX9 provides you with 10 volume steps controlled by the volume up and
volume down arrow buttons. The volume level is displayed on the remote
control screen.

5.7 Timer

The elapsed timer allows you to see how long you have been on a stand. The
timer starts as soon as you turn on the TX9 transmitter. You can reset the timer
by pressing the Auxiliary and Sound Up buttons simultaneously. The timer will
automatically reset to 00:00 if it is allowed to continue beyond the 99:59 mark.

5.8 Setting Presets P1 and P2

The TX9 allows you to have two presets. Each preset provides one button
access to your most frequently used sounds. The stored sound number of
presets is shown on the top right of the status line on the TX9 transmitter. The
associated volume is not shown (see the image below). To program a preset,
perform the following:
1. Press and hold P1 for 5 seconds. The top line of the TX9 display will
change to: "SEL SND/VOL PRESS P1"
2. Use the sound up/down arrow buttons to highlight the sound you wish
to have set on P1.
3. Use the volume up/down arrow buttons to set the volume level.
4. Press P1 a final time to lock in your preset.
Page | 11