Unpacking; Assemble Handles; Assemble Wheels; Assemble Rubber Strip - Craftsman 919.167210 Operator's Manual

Unpacking

1. Remove unit from carton and discard all packag-
ing. NOTE: Save all parts bags.
Assemble Handle
1. Insert the handle inside the compressor saddle
and line up the two bolt holes on each side.
2. Install the four screws, two on each side.
3. Tighten securely.
Handle
Rubber Strip
D23377
Screw
Nut
Wheel
Shoulder Bolt
8 - ENG

Assemble Wheels

outfit when installing the wheels because the
compressor will have a tendency to tip.
1. Attach wheels with shoulder bolts and nuts as
shown. NOTE: Place the bolts in the bottom hole
of the wheel bracket on units 20-29 gallons and in
the top hole on units 30 gallons and up.
2. Tighten securely. NOTE: The outfit will sit level if
the wheels are properly installed.
clearance, stability or support for pulling
the unit up and down stairs or steps. The
unit must be lifted, or pushed up a ramp.

Assemble Rubber Strip

1. Clean and dry underside of air tank leg opposite
wheels.
2. Remove the protective paper strip from the adhe-
sive backed rubber foot strip.
3. Attach the rubber foot strip to the bottom of leg.
Press firmly into place.
It will be necessary to brace
or support one side of the
The wheels and handle
do not provide adequate