Wiring Optional 240 Volt Plug; Section 7 – Maintenance (Onan-Powered Units); Routine Maintenance (Onan-Powered Units) - Miller Bobcat 250 NT Owner's Manual

6-3. Wiring Optional 240 Volt Plug

Current Available in Amperes
240 V Each 120 V Duplex
Receptacle* Receptacle
42
37
32
27
22
V x A = Watts
*One 240 V load or two 120 V loads.
SECTION 7 – MAINTENANCE (ONAN-POWERED UNITS)

7-1. Routine Maintenance (Onan-Powered Units)

Note
Follow the storage procedure in the engine owner's manual if the unit will not be used for an
extended period.
Check fluid levels.
See Section 4-2.
Check
spark arrestor screen.
See Section 4-2.
OM-4403 Page 26
7
0
5
10
15
20
20 h
and clean
1
3
4
120V
120V
240V
6
2
3
4
240V
6 5
Y Stop engine before maintaining.
.
See also Engine Manual and maintenance label.
Recycle
Service engine more often if used in severe condi-
engine
tions.
fluids.
* To be done by Factory Authorized Service Agent.
8 h
Wipe up spills.
Service air
cleaner wrapper
(foam element).
See Section 7-3.
The plug can be wired for a 240 V,
2-wire load or a 120/240V, 3-wire
load. See circuit diagram.
1 Plug Wired for 120/240 V,
3-Wire Load
When wired for 120 V loads, each
duplex receptacle shares a load
with one half of 240 V receptacle.
5
2 Plug Wired for 240 V, 2-Wire
Load
3 Neutral (Silver) Terminal
4 Load 1 (Brass)Terminal
5 Load 2 (Brass) Terminal
6 Ground (Green) Terminal
7 Amperes Available Using
120/240 V Plug
Tools Needed:
25 h
Continued
120 813-D