Picture Stabilizer Indicator - JVC GR-AXM99UM Instructions Manual

P. STABILIZER
RETAKE (R/F)
FEATURE: Quick Review
PURPOSE: To check the end of the last record-
ing.
OPERATION: 1) Press "
during the Record–Standby mode.
Distortion may occur at start of
NOTE:
playback. This is normal.
FEATURE: Retake
PURPOSE: To re-record certain segments.
OPERATION: 1) Make sure the camcorder is in the
Record–Standby mode.
2) Press either RETAKE button to
reach the start point for new
recording. Pressing "F" forwards
the tape and pressing "R" reverses
it.
3) Press Recording Start/Stop Button
to start recording.
Noise may appear during Retake.
NOTE:
This is normal.
FEATURE: Picture Stabilizer
PURPOSE: To compensate for unstable images
caused by camera-shake, particularly
at high magnification.
OPERATION: 1) Press P. STABILIZER. "
NOTES: Accurate stabilization may not be
possible if hand shake is excessive,
or under the following conditions:
• When shooting subjects with
• When shooting dark or dim
• When shooting subjects with
• When shooting scenes with
• When shooting scenes with low-
Switch off the Picture Stabilizer
when recording with the
camcorder on a tripod.
" and release quickly
Tape is rewound for about 2
seconds and played back
automatically, then pauses in
Record–Standby mode for the
next shot.
To switch off the Picture
Stabilizer, press P. STABILIZER.
The indicator disappears.
vertical or horizontal stripes.
subjects.
excessive backlighting.
movement in various directions.
contrast backgrounds.
23
EN
"appears.