D.s.c. Playback; Basic Playback - JVC GR-AXM99UM Instructions Manual

D.S.C. PLAYBACK

Page Button
System Select Switch
To move the page next
LCD monitor or viewfiner

Basic Playback

To move the page back
Still images shot using this camcoder are automatically
numbered, then stored in numerical order in the built-in
memory. You can view the still images stored in memory,
one at a time, much like flipping through a photo album.
SELECT MODE
1
Set the System Select Switch to "D.S.C.", then set
the Power Switch to "PLAY".
•The still image stored in memory is displayed.
•When no still image is stored in memory, the
screen becomes blue.
PLAY BACK
2
Press "W" or "T" located on the Page Button to
select the still image you want to view.
•Each time "W" is pressed, the page goes back,
while each time "T" is pressed, the page goes next.
•Even if you shoot a new picture after playing back
a still image with a low number, this will not
overwrite the existing picture because new
pictures are automatically stored after the still
image most recently stored in memory.
NOTES:
When the Power Switch is set to "PLAY" and the LCD
monitor is opened at an angle of 45 degrees or more,
the LCD monitor switches on and the viewfinder
switches off automatically to save power.
The playback picture can also be viewed in the
viewfinder (with the LCD monitor shut) or on a
connected TV ( pg. 46). Camcorder operation is the
same as described in this section.
When viewing a playback picture on a connected TV,
it may jitter slightly.
You can also view the playback picture on the LCD
monitor with it flipped over and retracted.
LCD monitor/viewfinder indications:
The battery pack remaining power indiator is displayed
for approx. 5 seconds on the LCD monitor when the
LCD monitor is turned on, and then it disappears.
However, the battery pack remaining power indicator
" " blinks when the power is almost gone.
55
EN