Hudson Year 1947 Owner's Manual page 47

HUDSON OWNER'S MANUAL
Figure 34
vals of 1,000 miles, using viscous chassis lubricant applied through the grease
fitting (D), Fig. 34, on the bottom of the pedal bracket, reached from underneath
the car.
Note: On oars equipped with Hudson Drive-Master this fitting is lubricated by remov-
ing the dirt shield screws and cover and applying the pressure gun to the grease fitting.
Every 5,000 miles the clutch should
be drained and refilled with HUDSONITE
CLUTCH COMPOUND, which is pro-
duced in the Hudson Engineering Laborato-
ries, and is available
Authorized Hudson Dealers and the
service stations of most of the reliable oil
companies. The exclusive use of this com-
pound is your assurance of obtaining
smooth, even clutch action.
The clutch is drained without disturbing
the flywheel guard by removing hex
plug (A), Fig. 35, in the front face of the
flywheel. Then rotate the flywheel until
the first star stamped on the flywheel
face appears in inspection hole over
starter motor and allow the old fluid to drain out. Turn flywheel until filler hole
reappears and refill with 1/3 pint of HUDSONITE CLUTCH COMPOUND.
Replace plug and tighten securely.
the floor board, 1
maintained between the floor board and
rear face of pedal.
This can be adjusted by loosening lock
nut (A), Fig. 34, removing cotter pin and
clevis pin (C), and turning yoke (B) to
increase or decrease the clearance as re-
quired. Replace clevis pin and cotter pin
and tighten lock nut securely.
LUBRICATION — The clutch thro-
wout bearing should be lubricated every
1,000 miles, using viscous chassis lu-
bricant applied through the grease fit-
ting on the right side of the clutch housing.
The clutch pedal and brake pedal shaft
bushings should also be lubricated at inter-
through all
45
1
/ " clearance must be
2
Figure 35