Wireless Lan; Disconnecting The Lan Cable - Toshiba Satellite X200 User Manual

3. Plug the other end of the cable into a LAN hub connector. Check with
your LAN administrator before connecting to a hub.

Disconnecting the LAN cable

To disconnect the LAN cable, follow the steps below.
1. Pinch the lever on the connector in the computer's LAN jack and pull
out the connector.
2. Disconnect the cable from the LAN hub in the same manner. Check with
your LAN administrator before disconnecting from the hub.

Wireless LAN

The wireless LAN is compatible with other LAN systems that comply with
the IEEE802.11a, 11b, 11g and Draft 11n wireless LAN standards.
It supports the following:
■
Automatic Transmit Rate Select mechanism in the transmit range of 54,
48, 36, 24, 18, 9, 6 Mbps for 802.11a/b/g and 802.11b/g wireless LAN
module.
■
Advanced Encryption Standard (AES) data encryption, based on 256bit
encryption algorithm.
Wake-up on Wireless LAN is supported on certain Wireless LAN model from
Sleep/Hibernate mode in AC adaptor mode.
(depending on the model you purchased.)
■
Frequency Channel Selection (5GHz and 2.4 GHz)
■
Roaming over multiple channels
■
Card Power Management
■
Wi-Fi Protected Access (WPA) data encryption
11a, 11b, 11g and 11n wireless are based on IEEE 802.11a, 802.11b,
802.11g and 802.11n respectively. The IEEE 802.11n specification has not
been finalized and is currently in draft release. The TOSHIBA 11a/b/g/n
Wireless LAN Adapters are based on the Draft Release, Version 1.0, of the
IEEE 802.11n specification. An Adapter with 11a/b, 11a/b/g or 11a/b/g/n
can communicate on any of its supported formats; the actual connection
will be based on the access point to which it connects.
Connection compatibility with the wireless equipment in Draft 11n mode is
not guaranteed.
The Draft 11n function cannot be used with WEP/TKIP. Draft 11n mode can
be used only with WPA-PSK (AES) mode or no security mode.
Satellite X200/Satellite Pro X200
Operating Basics
4-17