Sound System; Pointing Device - Toshiba Satellite X200 User Manual

Problem
No display
Display error occurs
Monitor goes into
panning mode

Sound system

Problem
No sound is heard

Pointing device

If you are using a USB mouse, also refer to the USB section in this chapter
and to your mouse documentation.
TouchPad/Dual Mode Pad
Problem
On-screen pointer does
not respond to Pad
operation
Satellite X200/Satellite Pro X200
Procedure
Try adjusting the contrast and brightness controls
on the external monitor.
Press hotkeys Fn + F5 to change the display
priority and make sure it is not set for the internal
display.
Check that the cable connecting the external
monitor to the computer is attached firmly.
If problems persist, contact your dealer.
Check your monitor specification. It might not
support the selected resolution and refresh rate.
The resolution on the monitor might go into
panning mode when wide screen resolution is
selected. Refer to Appendix B, Display Modes.
Procedure
Adjust the volume control dial.
Check the software volume settings.
If appropriate, make sure the headphone
connection is secure. Check Windows Device
Manager and ensure the sound function is
enabled and that settings for I/O address,
interrupt level and DMA are correct for your
software and do not conflict with other hardware
devices that you have connected to the
computer.
If problems persist, contact your dealer.
Procedure
The system might be busy. If the pointer is shaped
as an hourglass, wait for it to resume its normal
shape and try again to move it. You may also
press Fn + F9 to enable the TouchPad/Dual Mode
Pad and then try again to move it.
Troubleshooting
10-9