Recording Mode Setting; Loading/Unloading A Cassette - JVC GR-AXM4U Instructions Manual

SP/EP
Set POWER to "CAMERA"
4 4
2 2
1 1 5
Erase Protection Gear

Recording Mode Setting

1
Pressing SP/EP alternates the setting between SP
(standard play-provides higher picture and sound
quality, better for dubbing) and EP (Extended Play-
more economical, recording at 1/3 the speed of SP).
NOTE:
If the recording mode is switched during recording, the
playback picture will be blurred at the switching point.

Loading/Unloading A Cassette

OPEN LCD MONITOR
1
Press PUSH/OPEN and open the LCD monitor to an
angle of over 60 degrees.
OPEN CASSETTE HOLDER
2
Press EJECT until the holder opens. Do not use force
to open.
INSERT/REMOVE CASSETTE
3 3
3
Make sure the label is facing outward.
CLOSE CASSETTE HOLDER
4
Press PUSH and make sure the holder is closed and
locked.
CLOSE LCD MONITOR
5
First make sure the holder is closed. Then close the
LCD monitor.
NOTES:
Turn to take
up slack.
Closing the LCD monitor while the cassette holder is
still open may cause damage to the LCD monitor.
A cassette holder can't be opened unless a power supply is
attached.
Make sure that the tape is not slack when loading the
cassette. If there is any slack, turn the gear on the
cassette in the direction of the arrow to take up the
slack.
Make sure the Erase Protection tab is present. If not,
cover the hole with adhesive tape. (Some cassettes
have sliding tabs – in this case, check the tab's
position.)
13