Self-Timer - JVC GR-AXM4U Instructions Manual

34
Interval Timer Indicator
Tally lamp
START/STOP
INT. TIME
RM-V705U
(provided)
MENU
LCD monitor or viewfinder
Tele Macro
Gain Up
Co lor Filter
Tape Le ngth
Title
Da te/Time
Su b Men u
Main Menu Screen
Ta l l y
Int erv a l Ti me r OFF
Re c Time
JLI P I D N O.
Sub Menu Screen
RECORDING

Self-Timer

You can set the delay between pressing RECORDING
1min
START/STOP and the actual start of recording. If you
secure the camcorder, you (or whomever is operating the
camcorder) can enter the scene before recording starts.
1
2
3
4
+
5
–
FAR NEAR
6
OFF
7
AG C
NO R .
T30
To Release Self-Timer . . .
.... while the tally lamp is blinking, press RECORDING
ON
.... while the tally lamp is lit but not blinking, press set
OFF
NOTE:
07
Instead of performing steps 2 – 6, you can set the interval
time by pressing INT. TIME on the remote control.
Advanced Features (cont.)
ENGAGE RECORD-STANDBY
MODE
Make sure the lens cover is open, then set the Power
switch to "CAMERA".
SELECT MODE
Set the Shooting Mode selector to "PRESET".
ACCESS MAIN MENU SCREEN
Press MENU.
ACCESS SUB MENU SCREEN
Press – to move the highlight bar down to "Sub
Menu", then press NEAR. The Sub Menu screen
appears.
SET INTERVAL TIME
Press – to move the highlight bar down to "Interval
Timer", press NEAR, then press + or – to cycle
through the choices. Stop when the desired time
appears. Choose from "15S", "30S", "1min",
"5min", or select to turn the function "OFF". Then
press FAR twice to return to the Main Menu screen.
CLOSE MAIN MENU
Press MENU.
START DELAYED RECORDING
Press RECORDING START/STOP. If you set the tally
lamp to "ON" ( pg. 31), it begins blinking, and
the blinking frequency increases about 5 seconds
before recording is to start. Once recording begins,
the lamp stops blinking but stays lit.
START/STOP to stop the blinking, then set "Interval
Timer" to "OFF" or press INT. TIME on the remote
control until " " disappears.
"Interval Timer" to "OFF" or press INT. TIME on the
remote control until " " disappears.