Tape Dubbing - JVC GR-AXM341 Instructions Manual

Connections To A TV/VCR
1) Make sure all units are turned off.
2) Connect the camcorder to a TV or VCR using
optional video and audio cables. If using both
TV and VCR, connect the VCR output to the TV
input.
3) Turn on all units. Set the VCR to its AUX input
mode, and set the TV to its VIDEO mode.
• Use the AC Adapter as the power supply.
• Be sure to adjust the TV sound volume to its
minimum level to avoid a sudden burst of sound
when the camcorder is turned on.
• If you have a TV or speakers that are not
specially shielded, do not place the speakers
adjacent to the TV as interference will occur in the
camcorder playback picture.
Connector cover
TV
VCR
White to
Audio
6
Output
Yellow to
7
Video Output
A/V cable
To TV or VCR
White to
Audio Input
Yellow to
Video Input

Tape Dubbing

1) Connect the camcorder and the VCR
( "Connections To A TV/VCR"). Set the Power
0
Switch to "
and insert the appropriate cassettes in the
camcorder and the VCR. Engage the VCR's
AUX and Record-Pause modes.
$
2) Press 4/6 to find a spot just before the edit-
in point. Once it is reached, press 4/6
$
3) Press 4/6 and engage the VCR's Record
mode.
4) Engage the VCR's Record-Pause mode and
$
press 4/6 .
• Repeat steps 2) through 4) for additional editing,
then stop the VCR and camcorder when finished.
15
", turn on the VCR's power,
$
again.