Audio Dubbing; Insert Editing; Remote Control; Tape Counter - JVC GR-AXM341 Instructions Manual

Make sure the remote control is pointed at the remote sensor
Animation And Time-Lapse
The remote control lets you set/release interval
time and recording time without setting REC TIME/
INT. TIME ( pg. 21) in SYSTEM MENU.
Animation
Y
Each time ANIM. is pressed, the recording time
changes in the following order: 1/4S, 1/2S, 1S, 5S
and no indication (off).
Time-Lapse
Each time REC TIME
time changes in the following order: 1/4S, 1/2S,
1S, 5S and no indication (off). Each time INT. TIME
a
is pressed, the interval time changes in the
following order: 15S, 30S, 1MIN, 5MIN and no
indication (off).

Insert Editing

You can record a new scene onto a previously
recorded tape. Only the video signal is recorded in
this mode.
1) Set the Power Switch
2) Play back the tape, locate the edit-out point and
O
press PAUSE . Press and hold COUNTER R/M
*
for more than 1 second to reset the tape
counter, then press it again for less than
1 second so that "M" appears.
E
3) Press REW to go a little beyond the beginning
of the scene you want to replace, press PLAY
to view the recorded tape, and press PAUSE
exactly at the edit-in point where the new scene
should start.
4) While holding down INSERT
O
release PAUSE
USING THE REMOTE CONTROL UNIT
Y
is pressed, the recording
0
to " ".
T
, press and
. w appears.
u
.
5) To begin Insert Editing, press START/STOP
When the counter reaches "0:00:00", editing
stops automatically and the camcorder enters
the Insert-Pause mode. To end Insert Editing,
press STOP
• During Insert Editing, the original audio will be
heard from the speaker.
• After step 4), "Retake" (
performed.
• The tape may stop slightly before or after the
designated end point, and noise bars may appear.
Neither indicates a defect in the unit.

Audio Dubbing

You can record a new soundtrack on a
prerecorded tape (normal audio only). The sound
is recorded from the built-in microphone.
Perform steps 1) and 2) of the Insert Editing
procedure.
3) Press REW
of the scene onto which you want to dub the new
audio, press PLAY
then press PAUSE
dubbing should start.
4) While holding down A. DUB
release PAUSE
5) To begin Audio Dubbing, press PLAY
W
the counter reaches "0:00:00", Audio Dubbing
O
stops automatically and the camcorder enters
the Audio Dub-Standby mode. To end Audio
Dubbing, press STOP
• Do not press REW
Standby, or the edit points will not be accurate.
• If the microphone is too close to the TV, or if the
TV's volume is too high, whistling or howling may
occur.
For Insert Editing/Audio Dubbing
• Insert Editing and Audio Dubbing may not work
correctly if the tape contains blank segments, or if
the recording speed was changed during the
original recording.
• To edit/dub onto a tape, make sure the erase
protection tab is in the position that allows
recording.
• Do not press STOP
Audio Dubbing, or the edit points will not be
accurate.
24
(GR-AXM541 only)
R
.
pg. 13) can be
E
to go a little beyond the beginning
W
to view the recorded tape,
O
at exactly the point where
P
, press and
O
.
R
.
E I
or FF during Audio Dub-
R
during Insert Editing or
U
.
W
. When