Advertisement
Troubleshooting
S
y
m
p
o t
m
Cut blade does not cut
smoothly.
Film does not exit
dispenser between upper
and lower blade bars.
Film wrinkles don't
go away as crank is
turned clockwise.
Material will not
advance when crank
handle is turned.
Document wrinkles or
exits machine crooked.
Document peels from
mounting surface at
o
p
p
o
i s
e t
o c
n r
e
. s r
How to Change & Maintain your Cut System
Using the finger tab of the cut bar spring, pull in and carefully remove the cut bar assembly from
the machine (be cautions of exposed). Using caution, apply adhesive cleaner to all surfaces of bar
blade. Once adhesive build-up is removed, return the cut assembly to the machine, guiding the
location pins into the holes in the side plates.
Warranty Information
Xyron, Inc warrants that the XM1255 is free from defects inmaterial and workmanship for a period
of one (1) year from the date of purchase. Xyron, Inc. will repair or replace a defective product or
part without charge, with proof of purchase. If the product is damaged by neglect or misuse, the
warranty is null and void.
To register your product online, please go to www.xyronpro.com and click on the product
registration tab.
*If you purchased this product outside the United States Xyron will warrant this product in accor-
dance with the purchasing country's laws.
Customer Service
We want you to be happy with your purchase of a Xyron product. If for any reason you have a
problem or a question, please contact Xyron Customer Service toll-free at 1-800-793-3523 or
1-480-443-9419 for help. You can also e-mail us at: customerservice@xyron.com
For customer service outside of the U.S.
Australia: 61 2 8899 8500; australiacustomers@esselte.com
New Zealand: 64 9 272 1600; nzcustomers@esselte.com
Europe 44 845 67801801
Asia 813 5719 6450
©2009 Xyron, Inc.
8465 N. 90th St. Suite 6
Pima Center
Socttsdale, AZ 85258
Visit www.xyronpro.com for more information
C
a
u
e s
Adhesive build-up on
cutting mechanism.
Material is curled or
adhesive has been trans-
ferred to the nip roller
causing the film to stick
Adhesive build-up on
roller bars.
Material is not positioned
between rollers or laminate
is adhered to input tray.
Adhesive build-up on front
edge of input tray.
Improper peel technique
introduces curl in document. of peeling the liner from the
S
l o
t u
o i
n
Use caution and follow cleaning
procedure listed below.
Remove material and clean
adhesive from rollers if necessary.
Reposition material between
blade bars.
Apply adhesive cleaner to
remove build-up on roller.
Reinstall cartridge. Slide input tray
outward to release film and turn
handleto assure laminate is
wrinkle-free. Slide input tray back
into machine.
Remove adhesive from front edge
of input tray.
Use the proper peel technique
d
o
u c
m
e
t n
s a
h s
o
w
n
previous page.
o
n
h t
e
# 1445.03
Advertisement
