Advanced Presets - Moog Stage Edition User Manual

LP User's Manual - The User Interface
B. Advanced Preset menus
The Advanced Preset menu provides a set of additional programming parameters for each preset. These
parameters are stored individually for each preset.
FILTER POLES:
EGR RELEASE:
GATE:
FILTER SENSITIVITY (FILT. SENS):
Page 30
This menu allows you choose the number of Filter Poles for the
preset. The number of Filter Poles specifi es the fi lter response, from a
gentle 6db/octave (1 pole) to a steep 24db/octave (4 poles). To select
the number of Filter Poles, use the CURSOR button to highlight the
parameter, then use the VALUE knob to set the new parameter value.
Values: 1, 2, 3, 4
This menu allows you to turn the EGR Release parameter ON and
OFF. EGR Release is used to enable or disable the Release segment
of both the fi lter and volume envelopes. To change the status, use the
CURSOR button to highlight the parameter, then use the VALUE knob
to set the new parameter value.
Values: ON, OFF
The Gate menu allows you to select how the envelopes are triggered
when more than one key is pressed on the keyboard. A setting of
LEGATO ON means that the envelopes aren't retriggered until the key
is fully released. A setting of LEGATO OFF will retrigger the envelope
on a new note from the current EGR level. A setting of EGR RESET
will force the envelope generators to start from 0 volts each time a
note is triggered. To change the Gate mode, use the CURSOR button
to highlight the parameter, then use the VALUE knob to set the new
parameter value.
Values: LEGATO ON, LEGATO OFF, EGR RESET
The Filter Sensitivity menu allows you to select how the keyboard
velocity will affect the fi lter cutoff frequency. Positive values increase
the velocity sensitivity. This will raise the fi lter cutoff as the keys are
struck harder, mimicking the properties of acoustic instruments.
Negative values will have the opposite effect, lowering the fi lter cutoff
frequency as the keys are struck harder. To change the parameter, use
the CURSOR button to highlight the parameter, then use the VALUE
knob to set the new parameter value.
Values: -8... 0... +8