Moog Stage Edition User Manual page 26

LP User's Manual - The User Interface
LOCAL CONTROL/FINE TUNE (con't):
NOTE: While you are in this menu with AutoTune enabled, the output of the LP will be muted (the
Output ON/OFF button status will not change, however). The reason for muting the output is that
AutoTune uses a special Calibration Preset tone which isn't very musical. The LP's output will remain
muted as long as you stay in this menu, or until you disable AutoTune. If AutoTune is active when you
leave the menu, it will remain active but will automatically unmute the output and disengage when you
start playing. AutoTune has a special 'timeout' feature that waits 15 seconds after you stop playing
before engaging the AutoTune function in the background. If the AutoTune menu is displayed during this
time, you will see it change:
AUTO ...
Until the timeout is fi nished, at which point, the target note will appear again:
AUTO 60.12
The LP will continue to autotune while you are playing until you disable it in the menu, or until you
switch off the power.
For more on the Calibration Preset and a list of its parameter values, see Appendix B.
Page 28
When the Tune parameter is set to AUTO, the AutoTune function is
engaged and the display changes as shown. AutoTune works to keep
the LP in tune by automatically making fi ne adjustments to the Fine
Tuning CV.
When AutoTune is enabled, the display shows the actual value of the
last note played (displayed as the MIDI note number, shown here as
'60'), and the current tuning value (displayed in cents, shown here as
'.12'). In this mode, the LP will continually tune to this value. To adjust
the note that you are tuning to, cursor over to the Note value in
the display and use the VALUE knob for precise adjustments. Hitting
another note on the keyboard will set that note as the new target for
tuning. You can exit out this menu by hitting the MASTER or PRESET
buttons, and the LP will remain in the AutoTune mode, maintaining the
current tuning.
Values: Local Control - ON, OFF; the default is ON
Tune - ON, OFF, AUTO; the default is ON