Introduction; What You Need - Asko Dishwasher Installation Instructions Manual

INTRODUCTION

Read these instructions carefully and completely before
you install the machine. The installation should be carried
out by a qualified person who is familiar with all local codes
and ordinances for electrical and plumbing connections.
If a dishwasher is being installed in this area for the first
time, most of the cabinet work, plumbing, and electrical
has to be done before you move the machine into place.

WHAT YOU NEED

TOOLS
1) Phillips No. 2 screwdriver
2) Flat blade screwdriver
3) Torx screwdriver size T 20
4) Adjustable wrenches (if you use copper fittings)
5) Open-ended wrench (1/2˝ [12 mm] or 5/8˝ [16 mm])
6) Tape measure
7) Spirit level
8) Electric drill with 1-1/2˝ drill bit
9) Keyhole saw
MATERIALS SUPPLIED
1
4x / 3x
* Only select models.
Tip Guards (optional)
When it is not possible to attach the dishwasher to the
cabinet or the underside of the counter top, you should
install tip guards to prevent the machine from tipping when
you open the door. Sold individually.
Tip Guards
(P/N 8070851)
Page 2
*
3
*
2
Customer Care Center
1-800-898-1879
www.askousa.com
If you are replacing an old dishwasher, you must check
the plumbing connection and wiring before you move the
new dishwasher into place.
NOTE:
Cosmetic damage must be reported to the ASKO
dealer within five days from the date of purchase.
As soon as you unpack the dishwasher, thoroughly
check it for cosmetic damage.
MATERIALS
• Minimum 3/8˝ OD copper tubing of
sufficient length for your installation
• Shut-off valve and fittings for water
5
supply line
4
2x 2x
1"
(25 mm)
The dishwasher is shipped with the high loop drain hose,
inlet hose and electrical cord attached and ready to
be connected. Please do not remove the high loop
connection for the drain line.