Advertisement
8. Hook up the cab power supply wire to the positive
(+) post of the tractor starter motor. Secure the wire
to prevent contact with any hot or moving parts.
9. Raise the cab windshield and rest it on the opened
tractor hood.
B. Right side. Remove the bubble rubber seal that is
attached to the bottom edge of the assembly.
Install the front panel assembly in the cab by
slipping the brake pedal through the boot on the
assembly. Reinstall the bubble rubber seal and
position the assembly so that the (2) holes in the
assembly line up with the (2) holes in the right
front corner tube. Fasten the same as the left
side. Install the pocket mount bracket the same
as on the left side. Pull the cord on the boot up
tight around the brake pedal rod and tie it to seal.
Figure #10, 11 & 12.
E. Tighten the rear cab mount to tractor frame bolts
per the torque chart.
~.
Reinstall the tractor taillights.
i.
Reinstall the front pto shaft if so equipped.
10. Reinstall the (2) side engine covers.
SEAT
lILT
BRACKET,
LEFT SIDE
MY
---
7/16'
nT,
WASIfRS At{)
~T
Figure 9
11. Install the lower front panel assemblies. Attach the
ground wire assembly to the lower mounting bolt.
A. Left side. Position the assembly so that the (2)
holes in the assembly line up with the (2) holes in
the left front corner tube. Fasten with (2) 1/4" x
3/4" self tapping screws and (2) 1/4" flatwashers.
(A 1/4-20 tap may be used to thread the tube
holes.)
Install
the pocket
mount
bracket
by
slipping the short end behind the tractor tunnel lip
and fastening
it to the assembly with (1) 1/4" x
3/4" hexhead screw, (1) 1/4" flatwasher and (1)
1/4" lockwasher. Figure #10.
Figure 11
Figure 10
Figure 12
3
Advertisement
