Advertisement
MOUNTING INSTRUCTIONS FOR
JOHN DEERE 425, 445, 455
R.O.P.S. CAB
~
-
READ THROUGH THE INSTRUCTIONS BEFORE STARTING.
1. Preparation of the tractor.
A. Remove the (2) grab handles on the seat deck.
8. Open the hood.
C. Remove the taillights from the seat deck.
D. Remove the side engine covers.
E. Slide the seat to the farthest forward position.
F. Remove the front pto shaft if the tractor is so
equipped.
2. Install the front mount.
A. Attach the front cab mount to the tractor frame with
(4) 1/2" x 2" hexhead screws, (8) 1/2" flatwashers,
(4) 1/2" lockwashers and (4) 1/2" nuts. Do not
tighten completely at this time. Figure #1 and #2.
8. Install a rubber isolation mount into each of the
front mount plate holes. Figure #3.
Figure 1
3. Cab preparation.
A. (Optional - This step is not required but will make it
easier to work on the cab when mounting it.)
Remove the doors from the cab by removing the
spring clip from the end of the gas spring door
holder. Remove the gas spring from the ball stud.
Lift the doors off of the hinges. (This is also how to
remove the doors for summer use.)
c
8. Install (2) rubber isolation mounts into each rear
side cab mounting plate. Figure #4.
Figure 2
Figure 3
4. Set the cab onto the tractor.
A. Lift the cab by placing a strap through both door
openings.
8. Lower the cab onto the tractor. Line up the cab
front mount holes with the holes in the front
isolation mounts. Center the rear of the cab on the
tractor. Install (1) 3/8" x 2 1/2" hexhead screw, (2)
3/8" flatwashers, (1) 3/8" lockwasher and (1) 3/8"
nut into each front cab mount. Do not tighten at this
time. Figure #3. Install one end of the ground wire
assembly to one of the front mount bolts. The other
end will be attached to the cab when installing the
lower front filler.
Advertisement
