Fitting Protective Plate By 5Th Bow Motor, Rh Side - Saab 900 Convertible Manual

PSI
Fit a protective plate by the 5th bow motor on the right hand side to eliminate the risk of
the toothed segment damaging the wiring conriected to the 5th bow's potentiometer.
Parts:
Protective plate
Loctite Thread-Locking Adhesive
Screw (if necessary)
Operate the top using the "ROOF" switch until it is halfway raised and the Tonneau cover is fully upright. All
windows should be lowered.
2. Remove the two lower screws securing the 5th bow motor. See Figure 4.A.
3. Apply Loctite to the screw threads. See Figure 4.6.
4. Fit the protective plate in position and tighten the screws. See Figure 4.C.
Tightening torque: IONm (84-96in.lbs.).
45
59 951
45 55 710
4. Fitting protective plate bv 5th bow motor
Page 5 of 24