Table of Contents
Advertisement
36
When using a Lacuna, SatHawk, BirDog or SatBuddy digital satellite
location and identification meter, connect the LNBF to the meter and
use data for standard LNB type, KU, AMC4, Horizontal and Vertical
transponders. Peak for AMC4.
7.
Press the SIG button on remote to activate the Signal Strength
Level and Quality Install Screen with Signal Quality Tone Beeper.
8.
Find the satellite and peak Signal Quality reading by setting
the dish elevation and panning the dish side to side. Note: Signal
Level is not important at this time. If no Signal Quality is detected,
increase or decrease the elevation by one degree and sweep once
again. The elevation may need to be adjusted up to +/- 5 degrees
depending on the accuracy of the post leveling and mechanical
tolerances. Slightly rotate the LNBF to peak for the highest signal
quality. Signal Quality needs to be at least 50% + on this channel.
9.
Press CH/DOWN arrow to place the receiver on Hope Channel,
Ch. 1 (This is a weaker transponder).
10.
Verify the Quality reading is 50% +. If not, peak Quality
reading by fine tuning the dish angles and the LNBF rotation.
11.
Press SIG key to remove display. Installation is complete!
Installer Tip:
remove the AdventistSat LNBFs from the clamp and install a
DirecTV LNBF into the LNBF clamp. Locate the DirecTV 101w
satellite with a meter or DirecTV receiver. Replace the AdventistSat
LNBF into the clamp. The Dish is now roughly aimed and will only
require fine tuning for optimal reception of the linear satellite.
If you are having trouble locating the satellites,
©2008 AdventistSat.com
Advertisement
Table of Contents
