AdventistSat Fortec Mercury II Installation Manual page 32

Satellite system for reception of satellite amc4
Table of Contents

Advertisement

30
Satellite receiver displays "No Signal" only during very hot or
cold weather. LNBF is aging or is affected by temperature extremes.
Replace the LNBF.
Most of the channels have strong Signal Quality, but LLBN
signal quality is poor or the receiver displays "No Signal". LLBN
has a weaker signal than the other Adventist channels and may
display a low signal quality or no signal. Installations often need to
be fine tuned to receive this weaker station. Place the receiver on the
LLBN channel. Press the SIG key and make slight adjustments to
the antenna elevation, azimuth and the LNBF rotation and distance
from the reflector to peak the quality.
I only receive either the TV or the Radio Channels. How do I
switch between these services? Press the TV/Radio button on the
lower left corner of the remote control. This button toggles between
the TV and Radio services available.
Are more channels available? Many more channels are available
for viewing on this and other satellites. This receiver is capable of
automatically programming these additional TV and Radio services.
Many free national and international services are available. Do this
at your own risk, as AdventistSat will only provide the warranty
free technical support for the reception of
programming.
Scanning the Satellite for Additional Channels (optional)
1.
Press MENU on the remote, verify that the receiver is in the Installation
Menu. If not, VOL/RIGHT arrow to enter the Installation Menu.
2.
Select Power Scan and press OK.
3.
Select Satellite AMC4
4.
Highlight Mode and change setting to Scan FTA
5.
Highlight Start Scan press the OK to begin satellite scan. This process will
take approximately 10 minutes
6.
After the Scanning is complete, select YES to save the found channels
7.
Press EXIT on the remote to begin viewing channels.
Do not call to activate programming; all channels are free to air and
available with no monthly charge. The receiver assigns channel numbers
while scanning; therefore, no uniform channel line-up will be available
after a scan is performed.
the AdventistSat
©2008 AdventistSat.com

Advertisement

Table of Contents
loading

Table of Contents