Table of Contents
Advertisement
25
When the dish is aimed correctly
the "No Signal" indicator will
disappear,
programming
will
display and the Signal Quality
will display a 50% or better
quality level. These screen shots
show a Quality Reading of a dish
that is correctly aimed.
Once the correct satellite is located, make small adjustments in
elevation and azimuth until maximum signal is indicated on the
quality bar. The LNBF can also be slightly rotated within the LNBF
clamp +/- 5° to optimize the channel's signal quality reading. Slightly
loosen the two Phillips head screws that secure the LNBF clamp and
slowly rotate the LNBF left or right. Peak for highest signal quality
reading with the least amount of variations between the high and
low signal quality levels. Signal Quality readings should be 50%
or better to insure optimum picture and sound on the receiver. The
higher the quality, the better the reception. If the signal quality is
low the picture will break up into little squares and the sound will
become garbled and choppy or will disappear completely!
Press CH/DOWN arrow to place the receiver on Hope Channel, Ch.
1 (This is a weaker transponder).
Verify the Quality reading is 50%
or better. If not, peak Quality
reading by fine tuning the dish
angles and the LNBF rotation.
www.AdventistSat.com
Toll Free 866-552-6882
Advertisement
Table of Contents
