Warranty; Additional Information - Decware SE84CS Owner's Manual

DECWARE
To bridge a Zen amp, you simply either parallel or series the outputs of the amplifier. We
recommend series, which means take a positive from one channel and connect it to the negative of
the other channel with a short piece of wire. The remaining two unused posts will serve your
speaker.
USING YOUR AMP AS A MONO BLOCK CONT.
To bridge a Zen amp, you simply either parallel or series the outputs of the amplifier. We
recommend series, which means take a positive from one channel and connect it to the
negative of the other channel with a short piece of wire. The remaining two unused posts will
serve your speaker.
Remember that the inputs of both channels must see a signal if the amp is bridged. To do this
you can use a Y-Cable. If you decide permanent mono operation is in order we recommend you
send the amp back so we can short the input jacks together, and modify the volume control to
maintain the same 100K input impedance. This eliminates the need for a Y-Cable, and gives
the amp more gain which is handy if you are not using a preamp.
Unlike most stereo amps, bridging a Zen does not kill the fidelity. Most people who have done
so report added weight and smoothness to the presentation without loss of detail or focus. This
is made possible by the floating output transformers and the series connection of the outputs.

WARRANTY

Your new amplifier is built so well that during research and development we took one and
dropped it from a height of 15 feet onto concrete 40 times, followed by putting it into a paint
shaker for 24 hours. Badly beaten, the amp was retubed and played perfectly with ZERO
internal damage. This is why we offer you a lifetime warranty on parts and labor to the original
owner. You have purchased a 100% hand made amplifier of the highest build quality in the
industry. It was designed to give 30 years of trouble free service. Enjoy.
and design theory can be found at our web site:
Owner's Manual

ADDITIONAL INFORMATION

decware.com
DECWARE / High Fidelity Engineering Co.
1202 N.E. Adams Street Peoria IL 61603 USA
309-671-2428 Fax 309-672-1060 e-mail: fidelity@decware.com
www.decware.com (C)2000 All Rights Reserved
tm
www.