Chevrolet Orlando 2012 Owner's Manual page 309

Chevrolet Orlando Owner Manual - 2012
WARNING
Fans or other moving engine
parts can injure you badly. Keep
your hands away from moving
parts once the engine is running.
5. Connect one end of the red
positive (+) cable to the jump
start positive (+) post (B).
6. Connect the other end of the
red positive (+) cable to the
positive (+) terminal of the good
battery (A).
7. Connect one end of the black
negative ( ) cable to the
negative ( ) terminal of the good
battery (C).
8. Connect the other end of the
black negative ( ) cable to the
negative ( ) grounding point (D).
9. Start the engine in the vehicle
with the good battery and run
the engine at idle speed for at
least four minutes.
10. Try to start the vehicle that had
the dead battery. If it will not
start after a few tries, it
probably needs service.
Notice: If the jumper cables are
connected or removed in the
wrong order, electrical shorting
may occur and damage the
vehicle. The repairs would not be
covered by the vehicle warranty.
Always connect and remove the
jumper cables in the correct
order, making sure that the
cables do not touch each other or
other metal.
Black plate (75,1)
Vehicle Care
Jumper Cable Removal
A. Heavy, Unpainted Metal Engine
Part or Remote Negative ( )
Terminal
B. Good Battery or Remote
Positive (+) and Remote
Negative ( ) Terminals
C. Dead Battery or Remote
Positive (+) Terminal
10-75