Service Vehicle Soon; Light; Brake System Warning - Chevrolet Orlando 2012 Owner's Manual

Chevrolet Orlando Owner Manual - 2012
The DLC is under the instrument
panel to the left of the steering
wheel. See your dealer if assistance
is needed.
The vehicle may not pass
inspection if:
The malfunction indicator lamp is
on with the engine running, or if
the light does not come on when
the ignition is turned to ON/RUN
while the engine is off. See your
dealer for assistance in verifying
proper operation of the
malfunction indicator lamp.
The OBD II (On-Board
Diagnostics) system determines
that critical emission control
systems have not been
completely diagnosed. The
vehicle would be considered not
ready for inspection. This can
happen if the 12-volt battery has
recently been replaced or run
down. The diagnostic system is
designed to evaluate critical
emission control systems during
normal driving. This can take
several days of routine driving.
If this has been done and the
vehicle still does not pass the
inspection for lack of OBD II
system readiness, your dealer
can prepare the vehicle for
inspection.

Service Vehicle Soon

Light

For vehicles with this light, it comes
on if a condition exists that may
require the vehicle to be taken in for
service.
Black plate (15,1)
Instruments and Controls
Vehicles with an uplevel cluster
display a Driver Information Center
(DIC) message.
See Service Vehicle Messages on
page 5 30 for more information.
If the light comes on, take the
vehicle to your dealer for service as
soon as possible.

Brake System Warning

Light
The vehicle brake system consists
of two hydraulic circuits. If one
circuit is not working, the remaining
circuit can still work to stop the
vehicle. For normal braking
performance, both circuits need to
be working.
If the warning light comes on, there
is a brake problem. Have the brake
system inspected right away.
5-15