Chevrolet Orlando 2012 Owner's Manual page 177

Chevrolet Orlando Owner Manual - 2012
3. Use the dial or call command to
dial the number of the third party
to be called.
4. Once the call is connected,
press / to link all callers
together.
Ending a Call
Press / to end a call.
Muting a Call
During a call, all sounds from inside
the vehicle can be muted so that the
person on the other end of the call
cannot hear them.
To mute a call, press
then say Mute Call.
To cancel mute, press
then say Un-mute Call.
Transferring a Call
Audio can be transferred between
the Bluetooth system and the cell
phone.
The cell phone must be paired and
connected with the Bluetooth
system before a call can be
transferred. The connection process
can take up to two minutes after the
ignition is turned to ON/RUN.
To Transfer Audio from the
Bluetooth System to a Cell Phone
During a call with the audio in the
vehicle:
1. Press
2. Say Transfer Call.
To Transfer Audio to the Bluetooth
System from a Cell Phone
/ , and
During a call with the audio on the
cell phone, press
transfers to the vehicle. If the audio
/ , and
does not transfer to the vehicle, use
the audio transfer feature on the cell
phone. See your cell phone
manufacturer's user guide for more
information.
Infotainment System
Voice Pass-Thru
Voice pass-thru allows access to the
voice recognition commands on the
cell phone. See your cell phone
manufacturer's user guide to see if
the cell phone supports this feature.
To access contacts stored in the cell
phone:
1. Press
/ .
2. Say Bluetooth.
3. Say Voice. The system
The cell phone's normal prompt
/ . The audio
messages will go through their cycle
according to the phone's operating
instructions.
Dual Tone Multi-Frequency
(DTMF) Tones
The Bluetooth system can send
numbers and the numbers stored as
name tags during a call. You can
Black plate (31,1)
7-31
/ . The system
responds Ready, followed by
a tone.
responds OK, accessing
<phone name>.