Advertisement
INSTRUCTIONS FOR LIFTING AND MOVING OVEN
ATTENTION:
Only proper heavy lifting
machinery and handling equipment should be
used for unloading, moving and installing the
oven.
This duty should be performed by
professionals trained in this kind of work.
Improper handling of the equipment could
result in damaging the oven or personal injury.
1-
USING A FORKLIFT
Determine if forklift capacity is sufficient to lift
oven. (6000 lb for models 90 and 110, and
8000 lb for models 130 and 160)
Prior to lifting, make sure forks are long enough
to reach both horizontal steel tubes on
underside of oven (Without touching oven
shell). Approach oven from front entrance side
or rear side. Keep forklift straight. Carefully
place forks through inside of tube steel
supports legs and position under horizontal
tube steel members. Slowly lift and move oven
as needed. (See dia. A)
2-
USING A PALLET JACK
Determine if pallet jack capacity is sufficient to
lift oven. (4500 lb for models 90, 110, 130 and
6000 lb for model 160)
Prior to lifting, make sure pallet jack is long
enough to reach both horizontal angles at lower
end of steel tube support legs. Place pallet
jack between tube steel support legs
horizontal angles. (See dia. B) Carefully lift
oven and move slowly.
CAUTION:
OVEN IS TOP HEAVY MOVE
WITH CARE.
3-
INSTALLING OVEN
Slowly lower oven into proper location. Oven
should be set on a level floor.
necessary to assure that oven is level.
Remove horizontal front angle when oven is in
place.
inches in length, through base plates. (See fig
17-A pg. 7 in installation instructions)
DIA. A
under
DIA. B
Insert ramset red heads, min. of 3
Shim as
Advertisement
