Using The Separating Blade - Gemini Saw Company Taurus Ring Saw Manual

Slip drive belt and blade past blue
pulley #5, then wrap the drive belt
around it. From this point just
follow the previous steps in reverse
order.
COUPLING
Find the coupling.
Open the coupling and slide the
material with pre-drilled hole
through the gap. NOTE: When a
separating blade is installed, the
female side should always face
up. Put the blade back together
and slip the belt back on the
drive pulley #8.
The GOLDEN RULE when replacing
any parts in the saw is to rotate the
drive gear counter-clockwise by hand
several times to make sure everything
is rotating smoothly.
Lift the belt off of the drive pulley #8.
MALE
FEMALE
Page 10