Table of Contents
Advertisement
Displaying The Date And Time During Recording
When the Power Dial is set to "
during recording or not. You must first set the date and time (see "Date/Time Settings"
"DISPLAY" to "ON" in the Date/Time Menu. The Date/Time is always displayed when the Power Dial is set
to "
".
A
Display
REC MODE
SP
WIDE MODE
OFF
ZOOM
20X
DIS
ON
GAIN UP
AGC
FLASH
AUTO
TO DATE / TIME MENU
4
TO SYSTEM MENU
END
Recording Menu
ON SCREEN
OFF
DISPLAY
ON
DATE / TIME
RETURN
4
Date/Time Menu
1
SELECT OPERATION MODE
First turn the Power Dial to "
down the lock button located on the dial,
make sure the LCD monitor is open fully or the
viewfinder is pulled out.
2
ACCESS RECORDING MENU
Press MENU. The Recording Menu appears.
3
ACCESS DATE/TIME MENU
Move the pointer and highlight bar to "TO
DATE/TIME MENU" by rotating the Select Dial.
Press it and the Date/Time Menu appears.
4
SELECT FUNCTION
Move the pointer and highlight bar to
"DISPLAY" by rotating the Select Dial, then
press it. The pointer stops blinking, indicating
that the function has been selected.
5
SET FUNCTION PARAMETERS
Cycle through the available settings of the
selected functions by rotating the Select Dial
and stop when the one you want is displayed.
Then press it and the pointer and highlight bar
automatically move to "RETURN".
", "5S" or " ", you can choose whether to display the date and time
M
1 . 1 . 00
0 : 00
" while pressing
M
MENU
MENU button/
IND. ON/OFF button
6
CLOSE RECORDING MENU
Press the Select Dial twice. Selection is
complete and the menu disappears.
NOTES:
Connect the camcorder to a TV and set "ON
SCREEN" to "ON" in the Date/Time Menu. The
display appears on the connected TV .
The Indicator/Display function overrides these
settings. Even if you have set "ON SCREEN" to
"ON", pressing the IND. ON/OFF button for
longer than 1 second removes the indications
from the screen. Pressing it for longer than 1
second again makes the indications re-appear.
33
EN
pg. 11). Set
Lock button
Power Dial
Select Dial
Advertisement
Table of Contents
