US Robotics ADSL Ethernet Modem Overview page 3

Rear Panel Connectors of ADSL Modem
Connector Label
PWR Power Plug – connects to the power adapter.
LAN Ethernet Port – connects to the Ethernet port on
your PC or an Ethernet hub.
CONSOLE Management RS -232 Console Port – connects to
the serial port on your PC.
DSL ADSL Port – connects to the phone wall jack.
LAN Connector
The pin-out of the ADLS modem's RJ-45 jack is the same as a
standard Ethernet UTP jack.
Description
5
ADSL Connector
The RJ-11 jack of the Router uses pin 3 and pin 4.
Install the ADSL Ethernet Modem
1. Connect one end of the RJ-11 phone cord to the DSL port on the
rear of your ADSL modem. Connect the other end of the RJ-11
phone cord to your wall phone jack.
2. Connect one end of the Ethernet cable to the ENET port on the rear
of the ADSL modem. Connect the other end of the Ethernet cable to
the Ethernet port on the NIC in your computer.
Note: To connect the ADSL modem directly to a PC or to the uplink port
of a hub or router, use the Ethernet cable that was provided with
your ADSL modem. The Ethernet cable that came with your ADSL
modem is a straight-through UTP copper cable. To connect the
ADSL modem to a port other than the uplink port of a hub, a
crossover UTP cable must be used.
6