Connecting To An Hdtv - Video Only - AT&T U-verse VIP2200 Installation Manual

Connecting to an HDTV – Video Only
R F (75 Ohm )
connection
TO WALL
(VIDEO IN)
V ideo in
• Connect an RF coaxial cable to the cable wall outlet and the TO WALL (VIDEO IN)
connector on the TV receiver.
• If your HDTV has an HDMI input, connect an HDMI cable to the HDMI connector.
HDMI connection carries both video and audio signals.
• If your HDTV has a DVI input, you can use an HDMI to DVI converter to connect to the
VIP2200 HDMI connector.
• If your HDTV has component video, connect component video cables to the Y, Pb, and
Pr connectors.
DVI and component video carry video signals only. To connect the audio, refer to the
following page. To connect to a home theater receiver, refer to "Connecting to a Home
Theater Receiver – Audio Only. "
6
Com ponent video
connection
eSATA
NETWORK
OPTICAL
Pb
S am ple HDT V
Com ponent
V ideo Input
Y
Pb
Pr
VIP2200 Series High-Definition U-verse Receiver Installation Manual
connection
L R
Y
Pr
VIDEO OUT AUDIO OUT
HDM I
CA B LE /
A NT E N N A IN
HDM I
V IP2200
POWER
TO TV
HDMI
USB
+12V
(VIDEO OUT)
DC
E ither / or