Charging The Battery; Powering Your Phone On/Off - Zte Altair 2 User Manual

Removing a microSD card
1. Hold the Power key to power off the phone.
2. Remove the back cover and battery.
3. Carefully slide the microSD card out of the slot.

Charging the battery

Note: For best performance, charge the battery fully prior to using the phone
for the first time.
1. Insert the charger's connector into the charging port. Be sure to insert
the connector in the correct orientation. Do not force the connector into
the port.
2. Plug the charger into a standard AC wall outlet.
3. When the battery is fully charged, unplug the charger and disconnect it
from the phone.
4
Notes:
• The phone automatically powers off whenever the battery power is too low.
• Use only the charger supplied with the phone, or other chargers approved
by ZTE. Using an unapproved charger may cause damage to the phone
and may void your Warranty.
• If the battery is completely discharged or has not been used for an
extended period of time, the screen may not display the charge indicator
until the battery has been continuously charged for 10 to 40 minutes.
• Do not attempt to charge the battery at temperatures lower than 32°F (0°C)
or higher than 113°F (45°C).

Powering your phone on/off

Note: Take care to observe all posted signs and rules restricting or prohibiting
the use of handheld mobile devices.
Hold the Power key to turn your phone on or off.
GETTING STARTED GETTING STARTED 5