Getting Started; Phone Setup - Zte Altair 2 User Manual

Emergency service ......................................................................................... 54
HAC mode ...................................................................................................... 55
Troubleshooting and FAQs ................................................................................ 56
Specifications ..................................................................................................... 59
FCC compliance ................................................................................................ 60
Radio frequency (RF) energy ............................................................................ 61
Warranty .............................................................................................................. 63
Limited warranty ............................................................................................. 64
How to get warranty service .......................................................................... 65
Other warranty program ................................................................................ 65
Notes .................................................................................................................... 66
IV

Getting started

Note: In this user guide, "press a key" means to press the key and release it,
while "hold a key" means to press the key for at least two seconds and then
release it.

Phone setup

Removing the back cover and installing the battery
Note: If you do not plan to use the battery
for a long time, remove it from the phone
and store it in a cool, dry place.
1. Remove the back cover as shown.
2. Carefully insert the battery with the
contacts located against the metal springs.
3. Push down the battery until fully seated.
4. Replace the cover on the back of the phone.
Removing the battery
1. Hold the Power key to power off the phone.
2. Remove the back cover.
3. Lift the end of the battery near the top of the
phone to remove it.
CONTENTS GETTING STARTED 1