Troubleshooting - Philips CED110 User Manual

13 Troubleshooting

Warning
•
Never remove the casing of this product.
To keep the warranty valid, never try to repair
the product yourself.
If you encounter problems when using this
product, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips Web page (www.
philips.com/support). When you contact Philips,
make sure that the product is nearby and the
model number and serial number are available.
No power
•
Car engine has not been started. Start the
car engine.
•
Connections are incorrect.
• The fuse has been damaged. Replace the
fuse.
No sound
•
Volume is too low. adjust the volume.
•
Speaker connections are incorrect.
No response to the remote control
•
Make sure that the path between the
remote control and the unit is clear from
obstacles.
• Move the remote control close to the unit,
and point it at the iR sensor.
•
The function is not applicable to the
current media.
•
Replace the remote control battery.
The disc does not play.
•
The disc is upside down. Make sure that
the printed side is upwards.
•
The disc is dirty. Clean the disc with a
clean, soft, lint-free cloth. Wipe the disc
outwards from the center.
•
The disc is defective. Try another disc.
• The disc is incompatible. Try another disc.
•
The recordable disc is not finalized.
•
The region code of DVD disc is not
supported. Use a disc with proper region
code.
No image, or image flashes or is distorted.
•
Make sure that video cables between
this system and the screen are properly
connected.
Noise in broadcasts
• Signals are too weak. Select another station
with stronger signals.
•
Check the connection of the car antenna.
Preset stations are lost.
•
Battery cable is not correctly connected.
Connect the battery cable to the terminal
that is always live.
The fuse is broken.
•
The fuse type is incorrect. Replace it with
a 15 A fuse.
•
Speaker wire or power wire is grounded.
Check the connection.
EN
29