Currys Essentials CID45B10 Installation Instructions Manual page 10

INSTALLATION
13. Adjust the adjustable feet again to obtain the
optimum levelling of the unit.
14. Make sure your plumbing is suitable for use with
the dishwasher. If in doubt contact a qualified
plumber. This unit MUST BE connected to COLD
WATER MAINS using the new water inlet hose.
OLD HOSE SETS MUST NOT BE RE-USED. The
water pressure from the water mains needs to
be at a minimum of 0.04 MPa and a maximum of
1.00MPa.
• Connect one end of the safety water supply
hose to your dishwasher, and then connect
the other end of the hose to your water
mains. Please ensure the black rubber seal is
in place.
• After connecting the hose, turn on your water
mains and check for leaks.
• Connect the dishwasher to the mains socket.
You may use a Y-Adaptor (not included)
for an additional water feed for another
appliance, for example a washing
machine. This is only applicable for cold
water mains. A Y-Adaptor is available
from most DIY stores.
• Do not bend your drain hose.
GB-10
CID45B10_IB_110426.indd 10
screw
cone
gear
level
water mains
Y-Adaptor
(not included)
water supply hose
Connect to
another
appliance
if required.
4/26/11 8:15 PM