C. Hub Reinstallation
1.. To.reinstall.hub,.reverse.the.procedures.listed.
above.
2.. It.is.important.to.tighten.the.spindle.nut.to..
approximately.50.ft..lbs..(12".wrench.with.full..
hand force). Loosen the nut then finger tighten.
3.. Replace.the.cotter.
4.. When.reinstalling.wheel,.the.following.tightening.
procedure.is.recommended.by.the.manufacturer:
.
a.. Place.wheel.lug.nuts.on.by.hand.to.start.
.
b.. . T ighten.initially.to.15.-.20.ft..lbs..(Apply.20.
pounds.of.pressure.to.wrench.12".long).using.
cross tightening sequence. Proceed to finish .
tightening.to.85.ft..lbs..(Applying.85.pounds.
of.pressure.to.wrench.12".long.will.yield.85.ft..
lbs..of.torque).
.
c. Re-torque after first 50 miles of use.
Refer.to.Section.S-2G.for.additional.information..
on.wheel.requirements.
Trailer Information - Section S
Owner's Manual Page