Playback Controls - Canon EOS C500 PL Instruction Manual

Playing Back MXF Clips
7 Playback operation
Ð PLAY
Ý PAUSE
130
Ô/Ó
F FWD ×
Ø F REV
* The playback speed (x5, x15 or x60) will also appear in the indicator.
9 Relay recording
Appears when a clip begins on one CF card and continues uninterrupted on the other. 5 indicates the first
part of the recording, 6 indicates the middle part(s) and 7 indicates the last part.

Playback Controls

When you play back a clip, operate the buttons on camera's body or
on the monitor unit or use the joystick and joystick guide to use fast
playback, play back frame-by-frame or skip clips. Refer to the
following table.
Available Playback Types
Playback type
Fast playback
Frame advance/reverse
Skip to the beginning of
the next clip
Skip to the beginning of
the current clip
Skip to the previous clip
Return to playback mode
NOTES
• There is no audio during any of the playback types listed in the previous table.
• During some special playback modes, you may notice some anomalies (blocky video artifacts, banding, etc.)
in the playback picture.
• The speed indicated on the screen is approximate.
• During frame advance, the time advanced between frames depends on the video configuration used:
0.2 seconds (for 1280x720/24.00P, 1280x720/23.98P or 1280x720/59.94P), 0.25 seconds (for 1280x720/
50.00P) and 0.5 seconds for other video configurations.
• You can press the DISP. button to turn the joystick guide display on and off.
Playback
Playback pause
Frame reverse/Frame advance
Fast playback*
Fast reverse playback*
Operation
Buttons: Press the Ø or × button.
Joystick: During playback, push the joystick up or down.
Repeat to increase the playback speed to approximately
5x 15x 60x the normal speed.
Joystick: During playback pause, push the joystick up or
down.
Buttons: Press the Ù button.
Joystick: Push the joystick right.
Buttons: Press the Ú button.
Joystick: Push the joystick left.
Buttons: Press the Ú button twice.
Joystick: Push the joystick left twice.
Buttons: Press the Ò button.
Joystick: Press the joystick itself (SET button).