NETGEAR EX2700 Installation Manual page 14

I am connected to NETGEAR_EXT and launched a browser.
Why can't I see the web browser setup guide?
Try these troubleshooting steps:
• Make sure that your computer is set up to use DHCP (most are).
• Make sure that the Device Link LED is green and that you have a valid
IP address.
Relaunch the web browser and type www.mywifiext.net or www.
•
mywifiext.com in the address field. Enter admin for the user name
and password for the password.
How do I restore the extender to its factory default settings?
1. Use a sharp object such as a pen or paper clip to press and hold the
Factory Reset button on the bottom of the extender for at least five
seconds until the Power LED blinks amber.
2. Release the Factory Reset button and wait for the extender to
reboot.
The extender resets and returns to the factory default settings.
You can now access the extender from your web browser using the
factory default settings.
I enabled a wireless MAC filter (wireless access control or ACL) on
my router. What should I do when installing the extender?
14