Quick Oil Drain System - Bayliner 212 Runabout Owner's Manual Supplement

Chapter 3: Propulsion & Related Systems

Quick Oil Drain System

The quick oil drain hose was attached to the engine oil pan at the factory. However, some minor assembly is still
needed before you can use this system.
How to install the quick oil drain system:
1. Unscrew the factory installed
garboard drain plug from the gar-
board drain (A). Keep the factory
garboard drain plug on the boat
as a spare.
2. Unclip the quick oil drain assem-
bly from the wire loop (B) on
the engine.
3. Un-clip the draw cord section
(C) from the draw cord
section (D).
4. Thread the draw cord section
(D), the oil drain plug (E), and
the oil drain hose (F) through the
garboard drain (A).
5. Adjust the hose stop clamp (G)
so that no more than 12 inches of
hose, including the oil drain
plug, can extend out of the gar-
board drain (A).
6. Re-clip the draw cord section (C)
to the draw cord section (D).
7. Push the oil drain hose, oil drain
plug, and both sections of the
draw cords through the garboard
drain and into the bilge area.
8. Screw the oil drain garboard
drain plug (H) into the garboard
drain (A) and tighten firmly.
To drain the engine oil:
1. Remove the boat from the water.
2. Unscrew the garboard drain plug.
3. Pull the draw cord until the oil drain plug and the oil drain hose slide out of the garboard drain.
4. Place the end of the oil drain hose into a suitable container.
5. Unscrew the oil drain plug and drain the engine oil.
6. Replace the oil drain plug.
7. Push the drain hose back into the bilge.
8. Replace the garboard drain plug and tighten firmly.
Always dispose of waste oil in accordance with local regulations.
20
QUICK OIL DRAIN SYSTEM
TRANSOM
D
C
H
BILGE
A
212 • Owner's Manual Supplement
ENGINE
OIL PAN
F
E
FACTORY
INSTALLED
G
B