Link Optional Accessories To Wireless Network - Honeywell THX9321 Prestige 2.0 System Installation Manual

System Installation Guide

Link optional accessories to wireless network

5
If you need to return to the "Add Device" screen to add devices later, press MENU and scroll down to press INSTALLER
OPTIONS. Enter the date code (password) when prompted. The date code is printed on the back of the thermostat; or press
MENU > EQUIPMENT STATUS to find the date code. After you enter the password, scroll down to press WIRELESS DEVICE
MANAGER and then select ADD DEVICE.
Wireless outdoor sensor
Press and release CONNECT. After
a short delay the thermostat will
display "Wireless Outdoor Sensor
added" on the Add Device screen.
Portable Comfort Control
CONNECT
WIRELESS SETUP
The linking procedure will time out if there is no keypress for 30 minutes. To begin again,
press and hold in the lower right corner of the screen until the display changes (about 3
seconds).
RedLINK Internet Gateway
69-2490—05
Press and release CONNECT.
After a short delay, the status light
will glow green for 15 seconds.
Press CONNECT on the Portable Comfort Control display screen. Press DONE when the
screen displays "Connected," then exit or continue to link another thermostat.
Error messages:
E1 29
E1 34
E1 38
MCR32942
While the Add Device screen is displayed
on the thermostat, press and release the
CONNECT button on each wireless device, as
described below. Accessories need to be at
least 2 feet away from the thermostat or EIM
during the linking process.
Press DONE after all devices have been linked
Wireless indoor sensor
MCR32934
Incompatible device cannot be connected.
Low RF signal. Move device to a different location and try again.
Make sure the thermostat or the EIM is in Wireless Setup mode,
and the Portable Comfort Control is at least 2 feet away (600 mm).
Press and release the button on the bottom of the Internet
Gateway. After a short delay, the RedLINK status light will glow
steady green.
The Internet Gateway must be registered online before
use at www.mytotalconnectcomfort.com. Enter the MAC
ID and MAC CRC numbers located on the bottom of
the Internet Gateway. For additional information, see
MCR32943
instructions provided with the device.
6
MCR32935
If the status light turns red, the sensor did
not link with the thermostat.
In normal operation, this light remains off.
If it begins flashing red, batteries are low
(power will be depleted after 2–3 weeks).
MCR32958A