Link Thermostat To Wireless Network - Honeywell THX9321 Prestige 2.0 System Installation Manual

Heat pump systems
Hide thumbs Also See for THX9321 Prestige 2.0:
Table of Contents

Advertisement

Link thermostat to the wireless network
4
(if used with an EIM or TrueZONE Wireless Adapter)
Next, link all components and RedLINK
Initial powerup
When the thermostat is first activated, it will lead you through the steps
necessary to define and set up your system. The steps will change depending on
the type of system and thermostat you're installing.
Setup options for THX9321
If non-zoned system:
Setup for thermostat only
Setup for use with EIM
If zoned system:
Setup for EIM wired to zone panel
Setup for thermostat wired to zone panel
Setup for RedLINK wireless connection to zone panel
(using THM4000 TrueZONE Wireless Adapter)
Link thermostat to EIM or TrueZONE
Use the step-by-step thermostat menus to define your system type (above).
When you reach the Wireless Setup screen, follow the steps below:
C O N N E C
C O N N E C
"Connected" status light
Green flashing: In Wireless Setup mode.
Green steady: RedLINK device(s) are communicating.
Red: RedLINK device(s) not communicating. Check EIM and RedLINK devices.
At any screen you can press HELP for more information,
or press BACK to change earlier options.
S 2
S 2
T E D
S 1
T
S 1
MCR32941
THX9321/9421 Prestige
accessories to the wireless network.
Setup options for THX9421
If non-zoned system:
Setup for EIM connection
If zoned system:
Setup for EIM wired to zone panel
Setup for RedLINK wireless connection to zone panel
(using THM4000 TrueZONE Wireless Adapter)
Wireless Adapter
®
Press and release the CONNECT button at the EIM or Wireless
Adapter, and make sure the "Connected" light is flashing green.
If the "Connected" light does not flash, make sure no other
RedLINK devices are in Wireless Setup mode, then try again.
If the power light at the wireless adapter does not turn
on, consult the TrueZONE manual for help.
While the EIM light is flashing, press NEXT to link
the thermostat with the EIM. After a brief delay,
the screen will display "Device Connected."
5
IAQ and RF EIM
®
69-2490—05

Advertisement

Table of Contents
loading

Table of Contents